APPLICATION: For end trimming lumber, cants or ties up to a 9” thickness.
View the HMC ET-10 HS Trimmer Brochure
Tubular frame construction with wide flange beam upright supports.
Feed chains are #80 roller chain, powered via 3HP variable speed drive.
Strands are running on nylon slides and are moved via #60 roller chain.
Saws are 30” carbide, powered by 10HP TEFC saw arbor motors. Four (4) saws are included.
5HP variable speed electric vector drive for shifting saw.
HMI for set-up and programming.
Programmable 18 button setworks.
Drive enclosure with disconnect, includes 25’ of cabling.
Wiring for moveable strand contained within cable carrier.
Unit is pre-wired and tested at the factory.
Powered center strand
Belt conveyor with 2HP electric drive, not built into trimmer (18” wide belt)
Extra sets for setworks (each)
10” leg extension (required when belt is installed in trimmer)
Additional saws are available (Check with factory for current pricing.)HMC Waste Conveyors
The HMC WC-3 was designed specifically for HMC V-20 Debarkers. The unit consists of flat steel plates with a steel center divider and tail pulley take up assembly. Using a 5/8" proof coil steel chain with steel flights welded to it which sweep the bark from the area under the Debarker onto an inclined plate which discharges bark into a truck or pile.
90 degree left or right hand turn complete with double idler inside corner with chain.
Additional elevator trough with chain and flights.
Can be welded into the frame of the Debarker.